How can I judge a shutter installer’s remake and measurement error rate?
Ask for the remake records for a full season and look at the causes. Separate measurement mistakes from supplier faults and customer changes, and see who bore the cost of each. Then ask what the business changed after the last few errors, because the response shows more than a single number.
Ask the seller for a list of every remake or re-order, with the date, the reason and the cost. If there is no list, ask them to rebuild one from invoices and supplier credits. Sort the items into groups: measurement error, order error, supplier fault, damage in transit and customer change. Each points to a different part of the process.
Look at who absorbed the cost. If the business paid for most of them, ask your accountant how that shows up in the books, and whether the profit you are being shown already reflects it. If suppliers or customers took some of the cost, ask how that was agreed, and whether it was written down.
Then look at the response. After a bad month, what did the owner change? Did they add a second check, a different tool or training? Ask the installers what they think causes errors. Have your lawyer review any customer warranty wording, so you know what the business has promised customers about fit and remakes. The mix of causes matters more than any one figure. Ask also how long a remake usually takes and what the customer is told while they wait.
Key takeaways
- Build a list of remakes with date, cause and cost.
- Separate measurement errors from supplier faults and customer changes.
- Ask what the owner changed after each cluster of mistakes.
- Have your lawyer review customer warranty wording.
Related reading
15 pages on the same subject, grouped by topic.
Due diligence
- Expert answerWhat do measurement and ordering errors cost a window installation company?
- Expert answerHow can I check how long a window installer waits on factory lead times for orders?
- Expert answerHow do I check how a window installer sources caulking, flashing and foam for each job?
- Expert answerHow do I review a window installer’s records of remade or wrongly sized units?
- Expert answerHow can I judge a print shop’s error rate and reprint costs?
- Expert answerHow do I check a dental lab’s remake and rework rate with its dentist clients?
- Expert answerHow do I judge a shade sail installer’s mounting hardware inventory?
Buying
- Expert answerHow do I judge a window installer’s truck, lift and glass-handling cart setup?
- Expert answerHow do I check how a window and door installer handles warranty callbacks?
- Expert answerHow do I check a window installer’s storage of delivered units before installation day?
- Expert answerWhat should I know about a window and door installer’s showroom lead sources?
- Expert answerHow do I judge a hunting lodge’s blinds, stands and trail camera network?
- Expert answerHow do I review an auto glass shop’s remake rate for leaks and wind noise?
- Expert answerWhat should I ask about a playground installer’s mulch and rubber surfacing suppliers?
- Expert answerHow do I judge a shade installer’s sewing room and fabrication equipment?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentWhat are the steps to buying a business?
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.