How do I check a CNC shop’s probing and tool-setting equipment?
Ask the operators to demonstrate the probe and tool setter on a live job, and look at whether results are used or ignored. Working probing shortens setups and catches errors. Idle probing hardware often means unreliable equipment, missing training or macros nobody knows how to maintain.
Begin with a demonstration. Have an operator run a probing cycle on a part and a tool-setting cycle on a fresh tool. Watch how long it takes, whether the numbers update automatically and whether anyone double-checks by hand. Hand measurement after every cycle can mean the operators do not trust the system.
Then check condition. Ask about the stylus, the batteries or cables, the receiver and any damage from crashes. Ask when it was last calibrated and who did it. A machine fitted with a probe that is rarely switched on is a quiet sign of lost productivity or past trouble.
Finally, look for the software side. Ask whether anyone has customised the probing macros, offsets or cycles, and whether that work rests with one person. Ask where the programs are stored, whether they are backed up and who could fix them. Compare the setup times on a few repeat jobs, and ask whether the shop quotes setups assuming the probe is working. Ask what the probe is used for most: part alignment, in-process checks or broken-tool detection. Each shows a different level of skill on the floor. Ask for a spare stylus and a list of consumable parts, so you know the upkeep cost.
Key takeaways
- Watch a live probing and tool-setting cycle, start to finish.
- Check the stylus, cables and calibration records.
- Ask where the macros are stored and who can maintain them.
- Compare setup times on repeat jobs.
Related reading
15 pages on the same subject, grouped by topic.
Selling
Buying
- Expert answerHow do I check a small-engine shop’s tool and blade-sharpening equipment?
- GuideBuying a tool and die shop in Canada
- Expert answerHow do I check a remote starter shop’s wiring supplies and install tool kits?
- Expert answerWhat diagnostic tools should I expect in a computer repair shop sale?
- Expert answerHow do I inspect a transmission shop’s rebuild bench and torque converter tools?
Due diligence
- Expert answerHow do I check the tools and workshop equipment at a bike shop?
- Expert answerHow do I judge a locksmith van’s tool setup and on-board key machine?
- GuideTool and die shop due diligence
- Expert answerHow do I check an auto repair shop’s lifts and diagnostic tools before buying?
- Expert answerWhat should I look at in a motor shop’s balancing and test bench equipment?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
- 02Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.