What should I ask about a fab shop’s plasma table and its consumables use?
Start with how the table is used, not just its age. Ask how many hours it cuts in a typical week, what the torch parts cost to replace, how often, and whether the operator or the programmer decides when a part is worn out. Then see the receipts for consumables.
Ask to watch the table cut a real job. Look at edge quality, dross on the underside and whether parts come off square. Poor results often point to worn torch parts, a tired height control or a bed that needs attention. Ask who maintains it, whether a service record exists, and what the last major repair involved. Ask too how much downtime the table had last season and what the shop did with rush jobs meanwhile.
Consumables tell you how hard the machine really works. Request the supplier invoices for nozzles, electrodes, shields and gas, and compare them with the cutting volume the seller describes. If the spend looks light for the claimed workload, the table may be idle more than advertised. If it looks heavy, ask why, and whether a poor habit is wearing parts out early.
Also ask about the fume extraction, the downdraft bed or water table, the nesting software licence and the power supply. Find out whether one operator holds all the knowledge of the settings for each material and thickness, and whether those cut charts are written down or only in someone’s head. A table is only as steady as the person tuning it.
Key takeaways
- Watch a live cut and inspect edge quality before trusting the seller’s description.
- Compare consumables invoices against the cutting volume claimed.
- Ask where the cut settings are recorded and who knows them.
- Ask what the fume extraction and bed upkeep involve.
Related reading
15 pages on the same subject, grouped by topic.
Buying
- Expert answerHow do I assess a welding shop’s plasma table, press brake and welder condition?
- Expert answerHow do I assess a welding shop’s stock of steel, gas and consumables?
- Expert answerShould a formal wear shop own its rental tuxedos or use a wholesale rental supplier?
- Expert answerHow do I judge a glass shop’s cutting table and tempering supplier setup?
- Expert answerHow do I check an embroidery shop’s cash flow during its slow months?
- Expert answerWhat does a woodworking shop’s lumber supplier mix say about its stability?
- Expert answerHow can I check a butcher shop’s sales against its meat purchases?
- Expert answerHow do I check how an empanada shop makes and freezes its dough?
- Expert answerHow do I use a rustproofing shop’s yearly reapplication reminder list?
Due diligence
- Expert answerWhat should I check about a welding shop’s gas cylinder and consumables storage?
- Expert answerWhat should I look at in a print shop’s maintenance schedule for its presses?
- Expert answerHow do I check a leather workshop’s scrap and offcut use?
- Expert answerHow do I check a billiards hall’s table felt, cushions and levelling?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.