How can I tell if a fab shop’s shearing and punching equipment is near the end of its life?
Look for signs that the machine is fighting itself: blades that need frequent regrinding, burrs and uneven cuts, play in the ram or gibs, hydraulic leaks and repairs that keep returning. Add a check on parts supply. Equipment is near the end when fixing it becomes harder than replacing it.
Ask for a few test cuts or punched parts and measure them against the drawing. On a shear, check blade gap, square cuts, burrs and bowing of the sheet. On a punch, check hole position, burr height and noise on the stroke. Excessive vibration or oil leaking at the cylinders warrants a technician’s opinion.
Then go through the repair file. One big repair after careful use is different from a string of small ones, particularly on the same part. Ask about downtime: how often does the machine stop work, and how long does it take to get going again? A machine that sits idle often is already costing the shop even if the book value looks fine.
Ask whether parts and service for this model are still obtainable and how long they take to arrive. Old controls and obsolete tooling can limit the work the shop takes on. Ask what the shop would buy to replace it and how it would be paid for. List the equipment the business uses, noting which is owned and which is leased, and have your lawyer review the paperwork behind it. Ask your accountant what the machine’s age means for the books. A realistic plan for replacing it is part of the picture.
Key takeaways
- Measure test parts for squareness, burrs and hole position, and listen for strain on each stroke.
- Look for repeat repairs on the same component and ask about downtime.
- Check parts supply, and note whether the machine is owned or leased.
Related reading
12 pages on the same subject, grouped by topic.
Due diligence
Buying
- Expert answerWhat should I ask about a fab shop’s plasma table and its consumables use?
- Expert answerHow do I judge a fab shop’s press brake tooling and who can set it up?
- Expert answerWhat should I ask about a fab shop’s stainless and aluminum welding skills?
- Expert answerWhat should I know about a fab shop’s outside galvanizing and painting subcontractors?
- Expert answerHow do I tell if a muffler shop’s lift bays are enough for its job volume?
- Expert answerHow do I tell if a tea shop’s sales depend on its online store?
Selling
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
- 02Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.