How can I tell if a roll-former’s rollers and dies are worn?
Judge wear from the product first, then the tooling. Check cut samples for drifting dimensions, scratched surfaces or edge waviness, then inspect each roll for polish loss, scoring and flat spots. Ask for the tooling history, including regrinds and replacements, and ask a qualified machinist to confirm what you see.
Begin with the finished pieces, because worn tooling shows up in the product. Ask the seller for fresh samples from a full run and look along the length for twist, bow, scratched faces, uneven edges or dimensions that drift from one end to the other. Measure the samples against the profile drawing and, if the shop keeps them, against older samples or inspection records.
Then look at the tooling itself with the line stopped. Check each roll station for lost polish, scoring, pitting, flat spots and rust. Look at shaft and bearing play by hand and note any station that looks newer than its neighbours, since that often points to a past replacement. Photograph each station so your adviser can review it later.
Ask for the tooling history: when rolls were last reground, replaced or rebuilt, who did the work, and what spare sets are on the shelf. A shop that keeps these records usually looks after its equipment. A shop with none leaves you guessing, so allow for replacement cost in your own planning. Finally, have a qualified machinist or tooling specialist inspect the line with you. Their opinion on remaining life is more useful than a visual guess.
Key takeaways
- Measure fresh samples against the drawing for drift, twist and surface marks.
- Inspect every roll station and photograph it for your adviser.
- Ask for regrind and replacement records plus a list of spare tooling.
Related reading
12 pages on the same subject, grouped by topic.
Buying
Due diligence
- Expert answerHow can I tell if an e-bike repair shop’s rental fleet is worn out?
- Expert answerHow can I tell if an IT training centre’s lab computers are worn out?
- Expert answerHow do I tell if a shoe store’s returns of worn shoes are eating into margin?
- Expert answerWhat should I look for in a ceramics studio’s wheels and slab roller upkeep?
- Expert answerHow do I check a leather maker’s strap cutting dies and clicker press?
- Expert answerHow do I check a roller rink’s skate rental stock, wheels and bearings?
- Expert answerHow do I find out how a bike rental shop retires worn rental bikes?
- Expert answerWhat if the equipment turns out to be worn out?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.