How do I describe my sandblasting shop’s blast room size and part handling?
Give the inside dimensions of the blast room and the door opening, then the largest and heaviest part it can take. Describe how parts get in and out, such as cranes, carts or rails, and how they are supported. Add the media system and how the room is cleaned out.
Buyers picture capacity in terms of size and flow. Start with the numbers a customer would ask for: the inside length, width and height of the room, the door opening and the heaviest part you can load. Add a photo from the doorway and one from inside.
Then describe how parts move. Say whether you use a crane, a hoist, carts or rails, what each is rated for, and how parts are supported while blasting. Note the area outside the room for staging parts before and after. Tight handling can limit output more than the room does.
Describe the media system: the type of media, whether and how it is recovered and reused, and how the room is cleaned. Prepare totals for monthly media use and the hours the room runs, so a buyer sees how busy it is. Keep customer names and details out of the totals. Finally, add the equipment details a buyer will ask next: age, service history and any lease or financing, which your lawyer should review. Ask your accountant how to present the figures. Measure twice and use the same figures everywhere, so nothing in the documents contradicts the room itself.
Key takeaways
- Give the room and door dimensions and the largest and heaviest part you can load.
- Describe the crane, cart or rail system and the staging area.
- Show monthly media use and room hours as totals, with names removed.
Related reading
12 pages on the same subject, grouped by topic.
Buying
- Expert answerHow is buying a mobile sandblasting business different from buying a blast shop?
- Expert answerWhat should I ask about a coating shop’s blast room and abrasive supply?
- Expert answerHow do I size up the packing room of an online yarn business?
- Expert answerHow do I check a stamping shop’s press feed and coil handling equipment?
- Expert answerWhat should I ask about a machine shop’s coolant handling and chip disposal routine?
- Expert answerWhat should I know about a stone shop’s water recycling and dust handling?
Selling
- Expert answerHow do I describe my escape room’s themes and stories when listing it for sale?
- Expert answerHow do I describe my chocolate shop’s hand-painted bonbon production to a buyer?
- Expert answerHow do I get my coating shop’s customer racks and parts return process ready for a buyer?
- Expert answerHow do I document a cap maker’s range of styles and size runs?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaIndustryHow to sell your business
- 02Business Development Bank of CanadaGovernment7 steps to increase your business’ value—before you sell it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.