How do I show a buyer my fab shop’s layout and how material flows through it?
Draw the floor plan, then trace one path across it from raw stock to shipping. Mark the stations, the crane or lift points, storage and the places work waits. A buyer can then see where the shop is efficient and where it is cramped, before ever setting foot inside.
Start with a clean drawing of the floor, even a hand sketch scanned in. Mark the receiving area, stock racks, cutting, forming, welding, finishing, inspection and shipping. Add the cranes, lifts and aisles, and show where work waits between steps. Label each station with the equipment it holds.
Then lay one or two typical job paths over the plan, using arrows. Show how a part travels from stock to the loading dock. Be honest about bottlenecks: where work piles up, where forklifts have to cross paths and where space is tight. A buyer who finds these himself will wonder what else was left out, while a buyer who is told gets to plan for them.
Support the drawing with a few plain numbers: weekly throughput as a total by job category, with client names and details removed, and the hours each station runs. Tie the layout to the shop’s cash flow, since idle floor space and slow flow both cost money. Ask your lawyer about a confidentiality agreement before you share anything, and have the lease reviewed if the layout depends on the building. Photos taken from each corner of the floor, with the plan beside them, help a buyer picture the space before a visit.
Key takeaways
- Draw the floor plan and label each station with its equipment.
- Mark job paths and name the bottlenecks yourself.
- Give throughput as totals with names removed, after a confidentiality agreement.
Related reading
12 pages on the same subject, grouped by topic.
Due diligence
Financing
Buying
- Expert answerHow do I judge whether a fabrication shop’s shop floor layout limits growth?
- Expert answerHow do I judge a fab shop’s press brake tooling and who can set it up?
- Expert answerWhat should I ask about a fab shop’s plasma table and its consumables use?
- Expert answerWhat should I ask about a fab shop’s stainless and aluminum welding skills?
- Expert answerWhat should I know about a fab shop’s outside galvanizing and painting subcontractors?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernment7 steps to increase your business’ value—before you sell it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.