How can I judge the blast cabinet and abrasive recycling setup at a sandblasting shop?
Run the cabinet and watch it work. Check gloves, seals, viewing glass, lighting and nozzle wear, then follow the abrasive: how it is reclaimed, cleaned and fed back. A recycling system that separates dust and fines properly saves on media and keeps the cabinet cutting consistently.
Look first at the cabinet’s wear points. Gloves and port seals tear, the window frosts over, and door gaskets leak dust into the room. Each is cheap by itself but they add up, and their condition shows how closely the shop attends to small items. Look at the floor around the cabinet for spilled media.
Follow the media. A reclaim system should lift used abrasive, remove dust and fines, and return clean media to the pot. Look at the separator, the dust collector and the hoppers for clogging, holes and worn liners. Ask how often filters are changed and who handles the collected dust and spent media afterward.
Ask about the media itself: which types the shop uses for which jobs, how much is stocked and how much is used in a normal period. Ask for supplier arrangements and whether any media is bought on special order. Your lawyer can review any environmental or workplace paperwork, and your accountant can go over repair spending history. Request the equipment list with age and replacement dates, and ask a technician to inspect the system with you. Note the filter and hose condition on the same list, so wear is recorded beside the age of each part.
Key takeaways
- Check gloves, seals, window and nozzles on each cabinet, then follow the media through the reclaim system.
- Ask how dust and spent media are collected and handled.
- Request the equipment list with age and repair dates, and ask a technician to inspect the reclaim system alongside you.
Related reading
12 pages on the same subject, grouped by topic.
Buying
- Expert answerWhat should I ask about a coating shop’s blast room and abrasive supply?
- Expert answerHow is buying a mobile sandblasting business different from buying a blast shop?
- Expert answerHow do I judge a powder coating shop’s rework and rejected part rates?
- Expert answerHow do I check the curing oven and spray booth at a powder coating shop?
- Expert answerHow do I judge the racks and hooks inventory in a coating shop?
- Expert answerHow can I tell whether a powder coating shop is profitable before I buy?
- Expert answerWhat should I check before buying a powder coating shop?
- Expert answerHow do I judge a cabinet shop’s CNC router and edgebander condition?
Due diligence
- Expert answerHow do I check the booth filters and spray guns at a powder coating shop?
- Expert answerHow do I check a wheel repair shop’s CNC lathe and powder coating oven?
- Expert answerHow do I check a ceramic coating studio’s curing room or lamp setup?
- Expert answerHow do I judge the prep stage workflow at a ceramic coating studio?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
- 03Business Development Bank of CanadaGovernmentWhat are the steps to buying a business?
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.