How do I judge the age and resonator hours of a laser cutting bureau’s machine?
Start with the serial plate and the machine’s own hour counters, then compare them with the service history. Ask for resonator records, including any rebuilds or replacements, and see a live cut test. Counters can be misread or reset, so have a qualified technician confirm the readings.
Photograph the serial plate and note the model, build date and any upgrades. Then read the hour counters on the controller: most machines keep more than one, such as power-on time and laser-on time, and they are not the same number. Ask the seller to explain which one is shown and when it was last reset. On a fibre laser, ask the same questions about the laser source.
Compare those readings with paper. A service history should show resonator checks, any rebuild or swap, and the reason for it. If the resonator was replaced, ask when and whether the counter was reset with it. A gap between the date of the machine and the record of work done is a question to raise, not an accusation.
Watch the machine work. Ask for a cut test on a range of thicknesses and look at the edge, the dross, the pierce points and the consistency across the sheet. Poor results can come from the resonator, but also from optics or alignment, which is why a qualified technician should inspect the machine on your behalf. Finally, ask how much of the bureau’s output depends on this one machine, and what a long repair would do to the business. Write down every reading and date it, so you can compare them later.
Key takeaways
- Ask the seller which counter you are reading, since most machines keep more than one.
- Match counter readings against dated service and resonator records.
- Have a qualified technician inspect the machine and watch a live cut test.
Related reading
12 pages on the same subject, grouped by topic.
Buying
- Expert answerHow do I judge a grading company’s laser level and GPS machine control gear?
- Expert answerHow do I judge the condition of a sail loft’s large cutting table and floor?
- Expert answerHow do I judge the age and condition of a nursery’s potting machine and conveyors?
- Expert answerHow do I judge a laser tag arena’s wall obstacles and maze wear?
- Expert answerHow do I judge a glass shop’s cutting table and tempering supplier setup?
Due diligence
- Expert answerHow do I check how a machine shop buys carbide inserts and cutting tools?
- Expert answerHow do I read a 3D printing bureau’s machine hours and idle time?
- Expert answerWhy does a laser tag arena’s fog machine and haze fluid supply matter to a buyer?
- Expert answerHow do I judge the age and engine hours of a custom operator’s combine fleet?
- Expert answerHow do I check a machine shop’s spindle hours and machine service history?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.