How do I judge the condition of a sail loft’s large cutting table and floor?
Look at the table and floor in raking light and run a straightedge over them. Check for dips, seams, burn marks, and patched sections, then ask how the surface has been kept and what repairs were made. In a sail loft, flat and clean surfaces matter because cloth is cut to exact lines.
Visit on a quiet day and stand at one end with the lights low or side-on. Dips, ridges and joins show up clearly this way. Slide a long straightedge across the table and floor in several directions and look for gaps. Check the edges, the surface covering, and any places where heat from cutting tools has left marks.
Ask who built or installed the table and floor, what they are made of, and when any section was last replaced or levelled. Ask what the sail maker does to protect them: covers, cleaning routines, and rules for what may be set down. Look for tape lines, ruled markings and templates fixed to the surface, and ask which are still in use.
The size of the table and floor limits the largest sail the loft can lay out, so ask what the largest job has been. Ask what it would take to rebuild or replace the surface, and get a quote from a tradesperson rather than relying on the seller’s guess. Your accountant can advise how the equipment appears in the books. Photograph the surface in side light, so you can compare it with any later quote.
Key takeaways
- Check flatness with side lighting and a straightedge.
- Ask for the history of repairs, levelling and replacement.
- Get an outside quote for rebuilding rather than trusting a guess.
- Ask the largest job the table and floor have handled.
Related reading
15 pages on the same subject, grouped by topic.
Buying
- Expert answerHow do I judge a glass shop’s cutting table and tempering supplier setup?
- Expert answerWhat should I ask about a sign shop’s CNC router and cutting table?
- Expert answerHow do I judge the condition of a commercial cleaning company’s floor scrubbers?
- Expert answerHow do I assess a welding shop’s plasma table, press brake and welder condition?
- Expert answerHow do I judge whether a fabrication shop’s shop floor layout limits growth?
- Expert answerHow do I check the condition of a quilt shop’s cutting tables and design wall?
- Expert answerHow do I judge a board game café's table turnover on busy nights?
- Expert answerHow do I judge a cabinet shop’s CNC router and edgebander condition?
- Expert answerHow do I judge the condition of a machine shop’s CNC spindles before buying?
- Expert answerHow do I judge the condition of a precast plant’s forms and moulds?
- Expert answerHow do I judge a wrap shop’s large-format printer and laminator condition?
- Expert answerHow do I judge the age and resonator hours of a laser cutting bureau’s machine?
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.