What should I know about a fab shop’s plasma table and fume extraction system?
Check the table’s age, torch and controls, then the extraction system behind it: filters, ducting, the fan and how the collection is emptied. Ask for consumable costs, service records and downtime history. The extraction system is easy to overlook and can be costly to replace.
For the table, ask for its make, age, bed size, torch type and controls. Look at the slats, rails, drive and height control. Ask the seller to cut a few test parts and check the edge quality, squareness and holes against the drawing. Rough cuts may point to worn consumables, a tired torch or a table that needs adjusting.
For the extraction system, look at the hood or downdraft box, the ducting, the fan and the filters. Look for dented or patched ducting, clogged filters and signs that dust escapes around the table. Ask how filters are changed, how often and what it costs. Ask how collected material is emptied and stored. Ask for consumable purchases and filter replacements as totals by month, next to cutting hours. That shows the cost to run the machine.
Ask for service records and the longest breakdown. Ask what the shop would do if the table were down for a long time. Finally, ask a qualified technician to review the table and system with you, and ask your lawyer to review any lease or financing. Keep a written note of each reading and answer, and photograph the ducting and filter housing for your adviser.
Key takeaways
- Cut test parts and check edge quality, squareness and hole size.
- Inspect hood, ducting, fan and filters for damage and clogging.
- Compare consumable and filter totals with cutting hours.
Related reading
12 pages on the same subject, grouped by topic.
Buying
- Expert answerWhat should I ask about a fab shop’s plasma table and its consumables use?
- Expert answerHow do I assess a welding shop’s plasma table, press brake and welder condition?
- Expert answerHow do I check a welding shop’s ventilation and fume control equipment?
- Expert answerWhat should I ask about a fab shop’s stainless and aluminum welding skills?
- Expert answerWhat should I ask about a boat builder’s shop ventilation and dust extraction setup?
- Expert answerHow do I judge a fab shop’s press brake tooling and who can set it up?
- Expert answerWhat should I know about a fab shop’s outside galvanizing and painting subcontractors?
- Expert answerWhat should I ask about a sign shop’s CNC router and cutting table?
- Expert answerHow do I judge a glass shop’s cutting table and tempering supplier setup?
Selling
Sources
This answer is checked against primary sources. Links were last confirmed on the dates shown.
- 01Business Development Bank of CanadaGovernmentHow to conduct due diligence when buying a business
- 02Business Development Bank of CanadaGovernmentEquipment valuation: How to do it
Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.