Deavo
Due diligenceExpert answer · 1 min read

What should I check about a powder coating shop’s compressed air and filtration system?

Clean, dry air is basic to a good finish, so inspect the whole chain from compressor to spray gun. Check the compressor’s condition, the dryer, the filters and the drain points, and look for moisture or oil in the lines. Poor air shows up as craters or fisheyes, clumping powder and uneven coverage on finished parts.

Start at the compressor. Note its age, its maintenance log and how long it runs under load. If it runs loaded almost all the time, ask a technician whether it is undersized for the booth or losing air through leaks. Ask where the receiver tank is, how it is drained and what happens to the condensate.

Follow the line to the booth. Look for an air dryer, refrigerated or desiccant, and a coalescing filter, and see whether the filters carry recent change dates. Open a drain at a low point and look at what comes out. Water or oil in the sample explains much about the finish quality the shop gets. Check the hoses and fittings at the gun for cracks and leaks.

Then look at the booth filtration: cartridge condition, the pressure gauge across the filters and how often the shop replaces them. Ask how much powder is reclaimed and what the shop does with spent filters. Look at rejected parts and ask what the shop thinks caused the problem. List the equipment the business uses, noting which is owned and which is leased, and have your lawyer review the paperwork behind it. Ask your accountant about any equipment loans.

Key takeaways

  • Follow the air from compressor to dryer to filters to gun, and open a low drain to see what comes out.
  • Read the filter change dates and the compressor maintenance log.
  • Ask what rejected parts reveal about air quality, and what the shop changed in response.

Sources

This answer is checked against primary sources. Links were last confirmed on the dates shown.

  1. 01
    Business Development Bank of CanadaGovernment
    How to conduct due diligence when buying a business
    bdc.ca·Checked Oct 21, 2026
  2. 02
    Business Development Bank of CanadaGovernment
    Equipment valuation: How to do it
    bdc.ca·Checked Oct 24, 2026
  3. 03
    Business Development Bank of CanadaGovernment
    What are the steps to buying a business?
    bdc.ca·Checked Oct 21, 2026

Deavo is an advertising and listings platform, not a brokerage, law firm or valuation firm. This page is general information, not legal, tax, accounting or valuation advice, and rules differ by province. Confirm anything you rely on with a qualified professional before you act on it.